Setting up a Brick Paver Walkway or Clay Brick Manufacturers

The usage of Installing a Brick Paver Walkway or Brick Conveyor Belt or Pavers to produce a walkway or outdoor patio matches a house in a manner in which is unmatched. It includes a level of quality and beauty to a home entrance that can not be accomplished with either concrete or asphalt. Brick and Pavers also can be found in numerous different colors and shapes permitting for special color pattern and patterns to be achieved. In addition, setting up a Brick or Paver sidewalk does not always require a pro. With some standard understanding and a relatively easy walkway plan, a property owner can carrying out such a job.

The secret to setting up a Brick or Paver Walkway is to first appropriately prepare the location where the bricks/pavers are to be installed. The location should be dug out a minimum of a foot down, getting rid of all topsoil and clay soil. In addition, string lines must be strung on each side of the pathway. The string lines suggest the completed height of the walkway.
As soon as the location has actually been dug down, 3/4" gravel stone should be laid in and tamped down securely. 2" of sand, or stone dust should be spread out over the gravel. Again the sand/stone dust must be tamped down. Stone dust is preferred. The height between the tamped down sand and the stringline should equal the density of the brick or paver.

Now that you have a steady base, position a 1" pipe or journal board the length of the sidewalk on either side of the walkway. Then utilizing a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will develop a level area to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Set up a run on both sides of the prepared location. These strips will act as your walkway border and assistance to preserve the stability and shape of the pathway.

The key to laying the bricks/pavers is to ensure that they interlock with each other. Always stagger surrounding rows of bricks by 1/2 of a brick to interlock them. This will again assist preserve the stability of the pathway.

Undoubtedly bricks/pavers will require to be cut or split when constructing the walkway. Unless you desire to purchase or rent a pricey wetsaw, I would suggest purchasing an easy brick/paver splitter. It is generally a chisel with a broad end that is the width of the bricks/pavers. To actually cut/split the brick/paver, get more info lay it in a bed of sand and place the sculpt at a 75 degree angle over the spot where you desire to break the brick. Using a hammer strike the butt end of the chisel strongly. You may need to do this a couple of times. You might also want to turn the brick/paver over and strike the other side of the brick utilizing the hammer and chisle. Within a couple of strikes the brick/paver need to break cleanly. If your pathway has curves you will need to buy/rent a wetsaw.

After setting up the bricks, develop the outdoors edges with additional sand, and then shovel in the topsoil and load down strongly.
Spread stone dust over the new sidewalk and sweep into the cracks. This will complete the interlocking of the bricks and help to get rid of any weed development.


In addition, setting up a Brick or Paver sidewalk does not always require a pro. The secret to setting up a Brick or Paver Walkway is to first appropriately prepare the location where the bricks/pavers are to be set up. Now that you have a steady base, put a 1" pipe or ledger board the length of the sidewalk on either side of the pathway. These strips will act as your walkway border and assistance to maintain the integrity and shape of the pathway. Inevitably bricks/pavers will require to be cut or divided when building the walkway.

Leave a Reply

Your email address will not be published. Required fields are marked *